CRA CKLEE’ EFFECT

    • Type of substrate and preparation:
      • Any type of veneer or solid wood / MDF.
      • Preparation with NC, Polyurethane or PE sealer. Sanding.

     

    • Application of the “base for Cra-ckleè effect”.
      • Converter for Gammasat or Gammagloss coloured as required following our Tintometric System.
      • Application by spray reduced 40-50% with LZD010 – 120-140 gr/sq.mt.

     

    • Application of “Cra-ckleè effect”. After 6-12 hours, without sending.
      • LTT400 LAKREN TRANSPARENT coloured as required following our Tintometric System.
      • Application by spray reduced 50% with LZD083 + 10% LZD010 Retardant Thinner if required.
      • Adjust quantity and viscosity and wetting of substrate in order to reach the desired effect. Modify the thinner rate and opening of nozle.
        • Too much product and well wet: big cracks.
        • Few product and few wet: small cracks.

     

    • Finally overspray with transparent to protect the result after 4-6 hours without sanding:
      • Any transarent top coat, both matt or glossy can be used: NC, polyurethane or acrilyc two components.

It’s possible to apply one patina (LAT or LAS series) before the final transparent protection in order to give a old fashion  and deep looking.

E.O.F.

Codice lavorazione

WWC20

Category
cicli di lavorazione
This site uses cookies technical third-party in order to monitor access to the site. There is not profiling users . Accessing any item below this banner you are consenting to the use of cookies .
More about our cookies